Your first step will be to set up the correct time and date on your sprinkler controller. Simply turn the dial to “Current Time/Day” and use the directional buttons above until you see the correct day and time on the display. This information will be saved automatically. 2. Select Your Start Times. The Orbit B-hyve XR Smart Indoor/Outdoor Sprinkler Timer usually costs $30 less for an eight-zone system and $50 less for a 16-zone system, while the Orbit B-hyve Smart Indoor Irrigation X-CORE® PROGRAMMING GUIDE SETTING THE DATE AND TIME 1. Turn the dial to the CURRENT TIME/DAY position. 2. Use the or buttons to change the year. Press the button to proceed to setting the month. 3. Use the or buttons to change the month. Press the button to proceed to setting the day. 4. Use the or buttons to change the day. Sets up and adjusts optional Hunter Solar Sync sensor. 1. Press or – to select Region , 1-4 (see Solar Sync manual). 2. Press or to increase or decrease watering (see Solar Sync manual). Manual Station 1. Turn dial to Manual position. Press to select station. Use or +– to set manual run time. 3. Turn dial to Run position to begin immediately. Pilot Central Control; Total Top Service Rotors; Hunter Irrigation; Hunter Golf; Senninger Irrigation Lumascape; Dispensing Dynamics ©2024 Hunter Industries X-Core - Sprinklers Not Watering. If your controller shows irrigation running (Flashing Sprinkler Icon), and your sprinklers are not working, you may have a wiring problem at the valves or the irrigation water supply has been shut down. If you have a master valve on your system (check for wire on the P/MV terminal), then your master valve may Advanced Features. The X2 controller lets you keep the familiar, dial-based programming style offered by the Hunter X-Core® controller. If you upgrade your X2 to Hydrawise control with the plug-in WAND module, programming is fast and easy thanks to a helpful setup wizard. Hydrawise maximizes water savings by automatically adjusting irrigation The I-Core expansion module is designed to be used with the Hunter I-Core controller. This product allows for the user to extend their zone coverage by 6 additional stations at a time. The ICM-600 is compatible with both the metal and plastic enclosure Hunter I-Core controllers. The plastic model can be expanded from 6 to 30 stations while the Installation of the X-Core should only be done by trained personnel. 1. Route valve wires between the control valve location and controller. 2. At valves, attach a common wire to either solenoid wire on all valves. This is most commonly a white colored wire. Attach a separate control wire to the remaining wire of each valve. All wire OdpCu.

hunter i core irrigation controller manual